From f933fac994d18b72bfc2a190a00eae35bc47cd16 Mon Sep 17 00:00:00 2001 From: Bob Mottram Date: Sat, 10 May 2014 12:03:49 +0100 Subject: [PATCH] Cubieboard setup --- beaglebone.txt | 28 +++++++++++++++++++++++++++- 1 file changed, 27 insertions(+), 1 deletion(-) diff --git a/beaglebone.txt b/beaglebone.txt index 214d109d..ece2e9b1 100644 --- a/beaglebone.txt +++ b/beaglebone.txt @@ -103,6 +103,7 @@ The plug should be /centre positive/, meaning that the centre/tip is positive an Just an ordinary cat5 or cat6 cable that you can get from most electrical/computer stores. * Installing Debian onto the microSD card +** Beaglebone Black The Debian Linux OS will be installed onto a small flash drive. It's a good idea to do this rather than using the internal flash, because it will allow you to easily create backups of the entire system if necessary using the dd command. @@ -142,6 +143,29 @@ sudo ./setup_sdcard.sh --mmc /dev/sdX --uboot bone --swap-file 1024 Once completed then safely remove the microSD card via your file manager (usually right click and "safely remove" or "eject"). +** Cubieboard + +The Debian Linux OS will be installed onto a small flash drive. It's a good idea to do this rather than using the internal flash, because it will allow you to easily create backups of the entire system if necessary using the dd command. + +Download the Cubieboard image from http://cubian.org/downloads/ + +#+BEGIN_SRC: bash +sudo apt-get install p7zip-full +7z x CUBIAN_IMAGE.7z +#+END_SRC + +Create the disk image, where sdX is the name of the flash drive (probably it will be sdb or sdc). An easy way to find out the device name of the flash drive is to enter the command: + +#+BEGIN_SRC: bash +ls /dev/sd* +#+END_SRC + +then plug in the flash drive and type the same command again. You'll be able to see the difference. Once you know the device name then you can proceed to install the image onto the flash drive. + +#+BASH_SRC: bash +sudo dd if=EXTRACTED_CUBIAN_IMAGE of=/dev/sdX bs=4096; sync +#+END_SRC + * Setup #+BEGIN_VERSE @@ -167,6 +191,8 @@ Not knowing who you're really connecting to is especially true for self-signed c Eject the microSD card from your computer and plug it into the BBB, then connect the USB cable between the two. You may need to wait for a couple of minutes for the BBB to boot from the card, then you can then open a terminal and login via ssh. +Note that if you're using a Cubieboard then the ssh login is different (see https://github.com/cubieplayer/Cubian/wiki/Get-started-with-Cubian) and it may be easier to directly edit the following files with the microSD card plugged into your laptop. + #+BEGIN_SRC: bash ssh debian@192.168.7.2 #+END_SRC @@ -4275,7 +4301,7 @@ cd /opt git clone https://github.com/e14n/pump.io.git cd /opt/pump.io npm install -npm install databank-redis +npm install databank-leveldb #+END_SRC Limit the use of RAM by the Redis database.