Previously a count of the carraige returns and line feeds were stored
for end of paragraph runs, and a paragraph sign was stored as the actual
string. This was causing many special cases where the length of the
run needed to be determined differently if the run was or wasn't an
end of paragraph run.
There wasn't any use for storing the paragraph sign unless some drawing
code gets commented out to allow the end paragraphs to be shown,
therefore I changed the code to store the actual string that gets
retrieved by WM_GETTEXT.
EM_GETTEXTRANGE allows the start character offset and end characters
offset to be used to specify the range of text to retrieve. If the
start offset is in the middle of an end of paragraph run (i.e. \r\n),
then it should only retrieve the characters after the specified
character offset.
I found that ME_FindItemAtOffset and ME_CursorFromCharOfs are used
almost identically, except for how they handle a character offset that
is between a carriage return and line feed. In this case
ME_CursorFromCharOfs sets the cursor's run offset to 0, but
ME_FindItemAtOffset instead returns the next run which is what was
causing ME_LINELENGTH to incorrectly return the length of the next
line.
Previously this wasn't properly tested for, since all the lines had
text of the same length, so it wasn't properly testing to see which
line length it was getting.
riched32.dll does preserve the carriage returns and line feeds unlike
later versions of the richedit control, however the tests previously
missed the fact that a sequence of carriage returns followed by a line
feed (e.g. \r\r\r\n) can actually cause multiple paragraph breaks.
Several carriage returns followed by a line break were being handled as
a single paragraph break, when actually native richedit controls may
count this as several line breaks.
Using the WS_VSCROLL style causes the ES_AUTOVSCROLL option to be set,
and using the WS_HSCROLL style causes the ES_AUTOHSCROLL flag to be
set (except with richedit v1.0).
For some reason EM_POSFROMCHAR was returning 0 when the position was
equal to the end of the text, or beyond the end of the text. Instead
it should use the position at the end of the text for both these
cases. The x value was also seen to be offset by 1 according to the
tests.
Document remaining uses of bEmulateVersion10 and other checks for CRLF in editor.c.
Make RTF reader emit a \r or a \r\n according to emulation, not a \n, which breaks streaming tests.
Remove todo_wine from a bunch of riched32 tests that now succeed.
Alasdair Sinclair