This fixes an old regression when VK_RETURN handling was implemented
Wine-Bug: https://bugs.winehq.org/show_bug.cgi?id=23282
Signed-off-by: Fabian Maurer <dark.shadow4@web.de>
Signed-off-by: Huw Davies <huw@codeweavers.com>
Signed-off-by: Alexandre Julliard <julliard@winehq.org>
This is basically a no-op to make the tests and the following
additions simpler
Signed-off-by: Fabian Maurer <dark.shadow4@web.de>
Signed-off-by: Huw Davies <huw@codeweavers.com>
Signed-off-by: Alexandre Julliard <julliard@winehq.org>
There was a bug in ME_FindText which would cause the final caracter
offset to be incorrect when a paragraph was crossed while matching
characters. The problem was the character offset of the wrong
paragraph was used in the calculation of the start offset of the
match.
The width for EM_SETTARGETDEVICE is used by some applications to set the
wrapping width to a certain distance in twips. This can be used even
though the target device is ignored.
Previously a count of the carraige returns and line feeds were stored
for end of paragraph runs, and a paragraph sign was stored as the actual
string. This was causing many special cases where the length of the
run needed to be determined differently if the run was or wasn't an
end of paragraph run.
There wasn't any use for storing the paragraph sign unless some drawing
code gets commented out to allow the end paragraphs to be shown,
therefore I changed the code to store the actual string that gets
retrieved by WM_GETTEXT.
EM_GETTEXTRANGE allows the start character offset and end characters
offset to be used to specify the range of text to retrieve. If the
start offset is in the middle of an end of paragraph run (i.e. \r\n),
then it should only retrieve the characters after the specified
character offset.
I found that ME_FindItemAtOffset and ME_CursorFromCharOfs are used
almost identically, except for how they handle a character offset that
is between a carriage return and line feed. In this case
ME_CursorFromCharOfs sets the cursor's run offset to 0, but
ME_FindItemAtOffset instead returns the next run which is what was
causing ME_LINELENGTH to incorrectly return the length of the next
line.
Previously this wasn't properly tested for, since all the lines had
text of the same length, so it wasn't properly testing to see which
line length it was getting.
riched32.dll does preserve the carriage returns and line feeds unlike
later versions of the richedit control, however the tests previously
missed the fact that a sequence of carriage returns followed by a line
feed (e.g. \r\r\r\n) can actually cause multiple paragraph breaks.
Alexandre Julliard